The Most Common Plumbing Issue that You Can DIY - The Good Men Project
Okay. I removed a corner sink from a small bathroom. I replaced the sink with a corner tile countertop and vessel sink (one that the basin sits. If you install the p-trap backwards you don't get the velocity. I had a drain problem at my kitchen sink, and your information saved me a plumber call. to the second sink, a 45o pipe from the garbage disposal causes the I had my bathroom dual sinks replaced and did the installation of the p trap myself. I do not like the way the plumbing looks under my sink. We welcomed change orders if costs to meet our expectations exceeded those in the original The standard height for the waste line is 17" to 19" on a bath sink.
They are two different colors and one is a brushed rather than polished chrome. Teflon tape is also visible at one of the connections. Frankly, it looks like a a beginner DIY job with found bits and pieces joined together to make things work. I was home as the flexible mesh supply lines were about to be installed and those were changed to chrome.
I was not at home when the water was turned on and could not see how the drain would function or look.
The outlet to the waste pipe is 11 inches above the floor. Any of this plumbing could have been moved before the new walls and tile went up. I readily admit this was not something I knew anything about. That is why I hired someone with excellent references and provided pictures of my desired outcome.
To add to all of this, water pools in the sink instead of flowing freely into the drain. By the time the water gets hot, about three inches of water has accumulated in the sink It seems the pop up does not lift high enough for the water to flow freely.
I hope an adjustment there will solve this.
This was not a problem with the old sink. Needless to say, I am very disappointed with both the function and appearance of the final outcome. I have yet to turn anything on in the shower area as I'd like the contractor to be there for that experience. These are the questions I plan to ask the contractor: Is 12 inches from the sink drain outlet to the p trap a normal distance?
If a job was planned well, would two extensions really be necessary to connect the tail pipe to the p trap? Is the waste outlet usually centered between supply lines? Why is the p trap be turned to the right of the waste outlet?
How can we fix this? Okay, here it is — possibly the biggest money and frustration saving DIY plumbing tip — ever! So, the sink is draining freely again -right? Look at the pic below. The p-trap is the J-shaped piece, notice there are two — one on each side of the sink. One is connected to the disposal and the other is connected to the other half of the sink this is a double bowl sink.
What if your sink only has one p-trap?
Here are the basic steps. Place a towel in the bottom of the cabinet.
Length from sink drain opening to p trap | Terry Love Plumbing & Remodel DIY & Professional Forum
Yes, it might get a little wet and messy. Place a bucket or pan under the p-trap. Loosen the two connectors that hold the p-trap in place. You might need those pliers for a little encouragement.new bathroom vanity sink and pvc drain:plumbing tips
Note-the connectors are called slip-joint nuts and should be installed hand-tight! Many people over tighten them with pliers, which can cause the p-trap to warp so it is no longer perfectly round.
The Most Common Plumbing Issue that You Can DIY
This can cause a the p-trap to leak. When you have the slip-joint nuts loose, water will start to leak from the p-trap — this is normal.
- Length from sink drain opening to p trap
- bathroom sink drain pipe and p-trap don't meet
That is why you have the towel and the bucket. Loosen the slip-joint nuts all of the way and gently pull the p-trap loose from the rest of the drain assembly.